What are the precautions for wearing masks introduced by mask manufacturers?


Release time:

2024-03-14

What are the precautions for wearing masks introduced by mask manufacturers? What fabric is good for masks? Masks according to the material division, can be divided into non-protective cloth masks, sand cloth masks, activated carbon masks, the material is not the same with the safety protection over the effect is not related to the relevant is the overall design of the mask is reasonable, masks and face to meet the level of these.

  

What are the precautions for wearing masks introduced by mask manufacturers?


1, first clean hands and then wear masks, try to reduce the hand to touch the inside of the mask, as far as possible to reduce the probability of mask pollution;


2, don't wear the wrong front and back, also don't double-sided round wear, masks to distinguish between inside and outside, left and right, disposable medical general external masks, the outside is dark, the inside is light, there is a metal strip end is the top;


3. When wearing the mask, the folding surface should be carried out, the mouth, nose and jaw should be wrapped up, the elastic rope of the mask should be tightened as much as possible, and the metal strips on both sides of the nose should be tightened to reduce the leakage around and inhale slowly;

口罩生产厂家

4. When the mask is not needed, fold the side that touches the nose and mouth and put it in a clean packaging bag. After the mask is used and thrown away, it needs to be washed and disinfected;


5. The mask is replaced every 2-4 hours. If the mask is used for too long, the large fine particles will be blocked on the surface of the mask or the ultra-fine particles will block the gap of the mask filter system, thus causing the filtration efficiency to decrease and the respiratory resistance to rise. If the mask is damaged or polluted, it should also be replaced at the specified time;


6. After the mask is worn, do not touch both sides of the mask with your hands. Gram-negative bacteria gather on both sides.


mask manufacturer: what to choose a good fabric mask?

What fabric is good for masks? Masks according to the material division, can be divided into non-protective cloth masks, sand cloth masks, activated carbon masks, the material is not the same with the safety protection over the effect is irrelevant, really relevant is the overall design of the mask is reasonable, masks and face to meet the level of these.

Masks should be cleaned and disinfected daily. Both sand cloth masks and air purification masks can be heated and disinfected. Specific practices are:

1. Clean up: First use warm water and soap to gently scrub the cloth mask. The bowl-shaped mask can be gently cleaned with a soft brush dipped in detergent and washed with water. Please do not rub too hard, because if the space between the warp and weft net map of the sand cloth is too large, it will lose the anti-droplet infection effect.

2. Disinfection and sterilization: soak the cleaned mask in 2% peracetic acid solution for 30min, boil it in boiling water for 20min, boil it in a frying pan for 15min, and then wipe it for later use. This method is suitable for sand cloth masks and bowl masks.

3. Inspection: When using again, you should carefully check whether the mask and mask are still intact. For sand cloth masks and masks, the light transmittance detection method can be adopted. Take it in front of the lamp to see if there is obvious light spot and whether the light transmittance in the middle and part of the edge are the same. If not, please replace it with a new one.

Mask manufacturers have explained here today. Thank you for watching. Let's see you next time.


Key words:

RELATED INFORMATION

2024/03/14

Are you wearing a mask correctly?

Winter is a common season to wear masks, coupled with the impact of the epidemic, wear more. So you usually use the method of wearing a mask right? Next, the general medical mask manufacturers Xiaobian brief introduction, you can refer to see.

2024/03/14

How long can ordinary medical masks be worn?

The protective power and wearing time of ordinary medical masks are our concerns. Although it is important to pay attention to the filtering power when selecting medical masks, it is also necessary to select good sealing performance. So how long can ordinary medical masks be worn? The following small series for everyone to introduce:

2024/03/14

How to distinguish between ordinary medical masks and medical surgical masks

How to distinguish between ordinary medical masks and medical surgical masks, the following is a brief introduction: 1. The external packaging of medical surgical masks and ordinary medical masks is different. The implementation standards of registered products in the upper right corner of the outer packaging of medical surgical masks are different. Medical surgical masks are printed with YY-0469-2011, while ordinary medical masks are printed with YZB/and various manufacturers' labels.

2024/03/14

Methods and precautions for the use of medical masks

Medical masks are made of one or more layers of non-woven composite, the main production process includes meltblown, spunbond, hot air or needle, etc., with resistance to liquid, filter particles and bacteria and other effects, is a kind of medical protection textiles. The following medical mask manufacturers briefly introduce its use and matters: